Series 800M4QT

1 Inch Anti-Siphon Pressure Vacuum Breaker

Sizes 1/2" - 2" (15 - 50mm)

Features

• Replaceable plastic seat. 
• Easy maintenance of internal parts. 
• Acetal bonnet acts as "freeze plug" to prevent body damage. 
• O-ring bonnet seal for less possibility of fouling 
• Silicone seat disc for durability. 
• Test cocks positioned for easy testing and winterization.
• Compact space saving design. 
• Standardly equipped with tee handle quarter turn ball valve shutoffs ½" - 1" (15 - 25mm).  The 1¼" - 2" (32 - 50mm) feature lever handles. 
• No special tools required for servicing. 
• Bronze body for durability  

Specifications

An anti-siphon pressure vacuum breaker shall be installed where indicated on the plans to prevent the back-siphonage of contaminated water. This assembly is not to be used where there is a possibility that a back pressure condition may develop. The assembly will incorporate an acetal bonnet with silicone rubber O-ring seal and silicone rubber seat disc. The valve shall have replaceable seats. Check assembly shall be guided over its full stroke by ‘V’ notched guides. The assembly shall meet the requirements of ANSI/ASSE Standard 1020. Watts Regulator Company Series 800M4QT.

Materials

Models

Prefix: U – union connections (3⁄4" - 1" only)
Suffix: QC – Quick-Connect Adapters

Pressure - Temperature

Temperature Range: 33°F to 140° (0.5°C to 60°C)
Maximum Working Pressure: 150psi (10.3 bar)

Installations

This valve is designed for installation in a continuous pressure potable water supply system 12" above the highest point of the downstream piping. The valve must be installed with the supply connected to the bottom and in a vertical position. Allow adequate space for periodic inspection, servicing or testing. The valve should not be installed in an area where freezing or spillage will cause damage. Adequate drainage/freeze protection must be provided in cold weather applications. 1.5psi (10 kPa) must be exerted against the float spring to seal the float and air inlet. Do not undersize supply and discharge piping.

Important Note: Vacuum breakers are not designed, tested or approved to protect against backpressure backflow or water hammer shock. For protection against backpressure backflow, install Watts 909/009 Reduced Pressure Zone Backflow Preventer. For Protection against water hammer shock install a Watts Series 15 Water Hammer Arrestor utilizing good plumbing practice.